Original Banana Pi G1 Open Debugger Board Burner Module

Kenmerken

Conditie: Nieuw

Beschrijving

Original Banana Pi G1 Open Debugger Board Burner Module

Introduction:

Open Debugger is a set of programming tools in the development of STM series of microcontrollers, TI CC1x, 2x, TI CC3x series SOC, when STC Series MCU can be programmed quickly and easily debug, debugging programmer does not have to do something different series of chips switching plug tedious work.

In addition, it also integrates a USB to serial port, which is a common interface for embedded development.

It is also one of USB2.0 HUB, making it easy to extend to other USB tools.

With it, no longer need to face a bunch of different writer, complicated mess of wiring, USB port deficiencies.

Operating Condition:

Operating voltage: DC 5V

Operating temperature: 0°C to 85°C

The onboard voltage output: 3.3 V

Maximum output current: 2000 mA

Supported operating systems:

Microsoft Windows 2000

Windows XP SP2/SP3 operating system (32-bit versions)

Windows Vista operating system (32 and 64 bit)

Windows 7 operating system (32 and 64 bit)

Windows 8 operating system (32 and 64 bit)

Support Objects:

a)CC Debugger Interface:

Programming and debugging of the following 8051-based TI SoCs:

  CC1110, CC1111

  CC2430, CC2431

  CC2510, CC2511

  CC2530, CC2531, CC2533

  CC2540, CC2541

  CC2543, CC2544, CC2545

Control the same apparatus to SmartRF Studio. In addition, you can also control the following transceiver SmartRF:

  CC1120, CC1121, CC1125, CC1175

  CC1100, CC1101, CC110L, CC113L, CC115L

  CC2500, CC2520

It can also be used to program the PurePath wireless devices:

  CC8520, CC8521

  CC8530, CC8531

b)SWD Interface:

Programming and debugging mainstream ARM7 9 11, Cortex-A5 A8 A9 M0 M1 M3 M4

Supported MCU manufacturers:

ST, Freecale, Nuvoton, NXP, TI, Cypress, Atmel, Analog, Fujitsu, Toshiba, Energy Micro...

Speeds up the programming and debugging functions 4Mhz: Write Flash Rom, EEPROM,   ARF, and support for full speed, stepping, breakpoints

c)JTAG Interface:

JTAG programming and debugging interface for all supported kernel.

d)UART Interface:

STC series microcontroller programming and debugging output port for printing information.

Package included:

1 x Original Banana Pi G1 Open Debugger




Acronym table



CSn

Chip Select (active low)



DC

Debug Clock



DD

Debug Data



RST

Debug Reset



DUT

Device Under Test



GND

Ground



LED

Light Emitting Diode



MISO

Master In Slave Out



MOSI

Master Out Slave In



RF

Radio Frequency



SCLK

Serial Clock



SoC

System-on-Chip



SPI

Serial Peripheral Interface



USB

Universal Serial Bus



Target

Positive voltage on target



CLK

SWD Clock



DIO

SWD DATA Input/Output



TMS

JTAG Test Mode Select



TCK

JTAG Test Clock Input



TDO

JTAG Test Data Output



TDI

JTAG Test Data Input



SRST

JTAG Test Reset Input, Active Low



RXD

USB Serial Input



TXD

USB Serial Output



Bezoek onze webwinkel voor meer interessante producten!